Parker Chelsea Distributor 2 Way Valve AOHCD4C2 Tipper Valve

Parker Chelsea Distributor 2 Way Valve AOHCD4C2 Tipper Valve

 
Description:

1) Power: Hydraulic  
2) Material: Aluminum
3) Automatically locked in stop and fall position
4) Working medium:Air
5) Operating pressure(Bar): up to 12
6) Working temperature: -40℃-/+80℃
7) Nominal diameter(mm) 4
8) Weight: 0.6kg

Product Features:
1.Body Material: Aluminum
2.Seal Material: HNBR
3.Working Pressure: 0.5-12 Bar
4.Ambient temperature: -55℃-180℃
5.Port Size: M10*1
6.Automatically locked in stop and fall position
7.Transposition clearly
8.Able to coordinate with the Pneumatic control valve
9. Small Operating force
10.Simple operation
11.Easy to install
12..Long service life

Drawings
 

 
Mounting of the air control:
 
 When the air control is mounted next to the drivers seat a strong support should be used.
Available supports are:
-   092 32 002 for on-seat mounting
-   092 05 002 for on-floor mounting
Use always rubber grommets to protect air tubes and to prevent that dust and water enters the cabin.
For trouble free life of the entire pneumatic system the air system must be free from water.
The air control should be mounted in such a way that:
1   it is easy to reach by the operator.
2   it is no obstacle when entering or leaving the cabin.
3   it is clear from any moving parts such as drivers seat and closed door.
   The air exhaust connection must be brought outside the
cabin to prevent air entering the cabin, which gives the following disadvantages:
1   noise
2   blown up sand and dust
3   when alcohol is used to prevent the pneumatic system against frost the alcohol vapour will enter the cabin
o Make sure that air tubes:
1   are not too close to sharp objects.
2   are clear from moving parts.
3   are clear from exhaust and compressor lines.
4   can not get kinked.
5   are not too long.
note:     The air supply must always be tapped off from a accessory air tank or auxiliary valve and the 
pneumatic system must be protected with a charging valve.
( see guide - lines from truck manufacturer )
For operation of the air control see the Hyva
operation and maintenance instructions
 
Note: 
The air supply must always be taken from an accessory air tank or auxiliary valveand the pneumatic system must be protected with a charging valve.

Competitive Advantage:
 

 
Quality Standards :
 
The company for the products are brand new original products, no second-hand and refurbished products, or leave a compensable ten and return the full amount , but the buyer due to our purchase of model error is not responsible for returns, another of the company's sales of products enjoy one year from the date of shipment quality assurance , according to the original quality standards , during warranty with product problems , need confirmation testing by the manufacturer , the supplier to be solved , the demand side due to storage , use, poor maintenance caused by lower-quality product , and not raise objections 
 
Warranty:
 
All item Comes with Basic 3 Month Sellers Warranty, if item defective in 3 Month, We will offer replacement without extra Charger(including shipping fee)After we Receive the Defective item.
If item Defective after 3 Month, Buyers can still send it back, We will contact suppliers or Manufactory for Warranty. Buyers Might Need to pay the Shipping fee For resend the replaced item.